Free · Electronics and circuits calculators 💡

First-Order High-Pass Filter Design

Calculate cutoff frequency and ideal passband gain for passive RC or RL and active inverting or non-inverting first-order high-pass filters, with component inverses.

  • Formula & worked example
  • Private in your browser
  • No signup
Go to tool

Calculator inputs

Loading calculator…

How to use this calculator

  1. Enter the known values in the units shown. Results update as you type.
  2. Where results are editable, change one to solve backwards. Lock a value to hold it fixed.
  3. Use the worked example to check the method. Reset restores the starting fields.

Private by default

Inputs and results stay in this browser tab. Bookify does not upload or store the values you enter.

Formula and method

A 1000 Ω and 1 μF RC stage has a cutoff frequency of approximately 159.155 Hz. At cutoff the magnitude is 1/√2 of its passband magnitude.

RC: fc = 1/(2πRC). RL: fc = R/(2πL). Active gain: −Rf/Rin (inverting), 1 + Rf/Rg (non-inverting).

Worked example

Enter these known values and leave the other values blank.

Filter type
RC (passive)
Resistance (R)
1000 Ω
Capacitance (C)
1 μF
Cutoff frequency (F==c==)
0.15915 kHz

Assumptions and limitations

  • All four modes are ideal first-order high-pass circuits with positive finite components and positive cutoff frequency. The passive output is unloaded; connecting a load changes the transfer function.
  • The RC time constant is in seconds when resistance is in ohms and capacitance in farads. R/L has dimensions s⁻¹. Divide angular cutoff frequency by 2π to obtain hertz.
  • For the inverting high-pass topology, cutoff uses the input resistor Rin and input capacitor C. Its signed passband gain is −Rf/Rin. The non-inverting mode uses the input RC network and gain 1+Rf/Rg.
  • An ideal op-amp is assumed: unlimited gain bandwidth, no slew-rate limit, zero bias/offset currents and no output clipping. Check real supply voltage, stability, loading, component tolerance and manufacturer bandwidth limits separately.
  • A first-order cutoff is the frequency at which amplitude falls to 1/√2 of the applicable passband amplitude, approximately −3.0103 dB relative to that passband. It does not imply a unity-gain filter.
  • Each component, cutoff and gain can be edited where the inverse has a unique physical value. The non-inverting gain must exceed one with both feedback resistors positive; unity is a limiting case outside the positive-resistor inverse.
  • Controls accept decimal/scientific-notation numbers and bounded exact finite-decimal arithmetic. Expressions that lose input digits or exceed the proof budget are rejected. Nonzero entered values below 10⁻¹⁰⁰⁰⁰ in equation base units are outside the supported working range. Arithmetic results use 64 significant digits; tiny representable values use scientific notation, and an overflowing or zero-losing unit conversion is withheld with an error.

Common questions

Which resistor determines an active cutoff?

In the inverting high-pass circuit, Rin and the series input C set the cutoff. Rf/Rin separately sets gain magnitude.

What is the cutoff of 1 kΩ and 1 μF?

The time constant is 0.001 seconds, so fc = 1/(2π × 0.001) ≈ 159.155 Hz.

Can a passive filter provide voltage gain above one?

These unloaded first-order passive RC and RL topologies have unity asymptotic passband gain. Active op-amp modes can have larger passband gain.

References

The calculation equations, inverse formulas, units, and input rules were imported from this source. Bookify provides the interface and equation solver.

Explore electronics and circuits calculators 💡 or browse all physics calculators.